The Filterfalls is an up-flow filter. Water flows from the pump through the bulkhead fitting into the swirl chamber at the bottom of the filter enclosure; then through the grate and filter mat where solids are removed. Lastly, through the media bag and filter material, and out over the spillway.

• Container is ruggedly built from high molecular weight polyethylene (.250 inch gauge).
• 42 inches L x 53 inches W x 19 inches H
• 50 inch Spillway
• Max. Flow: 15,000 GPH
• Container Capacity - 230 Gallons
• Includes: Grate, Tray, Media Bags (for adding additional filter material such as Springflo Bio-Filter Media), Filter Mat, & a 3 inch Bulkhead
  (see table below for recommended plumbing connections)
• 3" FPT Inlet at rear of filter
• Installation Instruction

Use the following table to help determine the necessary fittings for this pond filter. Please note you may also need PVC cement and/or Teflon tape to make connections.

To connect the FilterFalls to:
Pipe Size & Type	Use These Connections  (click links for kits containing all needed connectors)
1-1/4" Tubing	3" Male Adapter, 3" x 2" Bushing, 1-1/4" Bushing, 1-1/4" Male Insert, Hose Clamp
1-1/2" Tubing	3" Male Adapter, 3" x 2" Bushing, 2" to 1-1/2" PVC Reducing Bushing, 1-1/2" PVC, 1-1/2 inch Female Adapter, 1-1/2" Male Insert , Hose Clamp
1-1/2" PVC	3" Male Adapter, 3" x 2" Bushing, 2" to 1-1/2" PVC Reducing Bushing
2" PVC Pipe	3" Male Adapter, 3" x 2" Bushing
3" PVC Pipe	3" Male Adapter